Dental Radius Cutters for HinriMill 4, 35 mm length

Dental Radius Cutters for HinriMill 5, 40 mmlength

Dental Radius Cutters for HinriMill 4, 35 mm length

Dental Radius Cutters for HinriMill 5, 40 mm length

 

Dental Radius Cutters for HinriMill 4, 35 mm length

Dental Radius Cutters for HinriMill 5, 40 mm length

 

Dental Radius Cutters for glass ceramic

for HinriMilll N4, Z4, 5, 5.8 and R5
35 mm length

Milling cutters for HinriMill 4, 32 mm length

 

Milling cutters for HinriMill 5, 35 mm length

 

Dental Radius Cutters for HinriMill 4, 35 mm length

Milling cutters for HinriMill 5, 35 mm length

 

HinriMill 4 cutter for nanocomposites with special coating, 35 mm length

Dental Radius Cutters for HinriMill 5, 40 mm length

 

A unique innovation of our milling machines E5 and E4 is their freedom from compressed air. They require neither an external compressed air connection nor a built-in compressor.

Due to the high speeds of the high-frequency spindle, the turbine blades on the AIRTOOL generate a strong air flow towards the cutting edge of the tool, which keeps the workpiece free of chips and dust. In turn, chips and dust are removed by the connected suction unit. Thus, you can work without a compressed air connection and avoid the corresponding disadvantages. With these two machines E4 / E5 and the AIRTOOLs, you enjoy maximum freedom in choosing the installation site and benefit from significantly lower operating costs.

The AIRTOOLs are only required for the first milling steps – the roughing process – which produces a particularly large amount of chips. Therefore, they are only available with cutting edge diameters from 2 mm. For the finer finishing process, you still use the standard tools.

The E5 and the E4 have a separate slot in the tool changer for the AIRTOOL. This means that your restorations are of course also produced fully automatically in the E series.

The color coding also shows for which material the respective AIRTOOL is used.