Made of plastic for the 6 kg container. Pump with lid.
Pump with lid (white), component A / REF 891030
Pump with lid (red), component B / REF 891031
For stabilizing the silicone mould when using the flaskless duplicating procedure. Supplied in four sizes.
Stabilizer, Size 1 (57 x 44 mm) REF 891003
Stabilizer, Size 2 (62 x 48 mm) REF 891004
Stabilizer, Size 3 (66 x 55 mm) REF 891005
Stabilizer, Size 4 (72 x 60 mm) REF 891006
Plastic duplicating flask with 3 sections for cost saving, problem-free duplicating with Hinrisil®. Consists of a flask base, flask ring and stabilizer.
Supplied in two sizes.
Flask complete, size 1 (68 x 81 mm), set / REF 891020
Flask complete, size 2 (73 x 91 mm), set / REF 891021
Device for flaskless duplication without the fixation device.
A practical accessory when the duplicating material is to be vulcanised cured under pressure.
REF 891002
Device for positioning the stabilizer when using the flaskless duplicating procedure.
REF 891001
Save silicone with the flaskless duplicating system
The starter set contains all necessary products for the flaskless duplicating system to allow a economical duplicating and investing for the production of partial frameworks.
Content:
2 x 1 kg Hinrisil® Speed 1:1
1 x 40 m adhesive duplicating tape
3 x Stabilizer Size 2
1 Fixation device
1 x 250 ml Hinrisol
1 x 25 m disposable ring tape
1 poster duplicating technique
1 poster investing technique
1 produkt catalog
(also single available)
REF 891999